Dip coat

The dipcoat is sprayed with a coarse sand while it is still wet.

From the practical point-of-view, the basis of the investigation was that one should apply the primary dipcoat to pattern-assemblies using two different dipcoat-viscosities, two pattern-washing techniques, and two methods of draining the...

To assure adherence of the dipcoat to the wax, prewetting in a suitable agent to remove mold parting lubricant and microscopically roughen the wax surface may be necessary.

If one or more of the slurry components reacts with the silica binder, dipcoat gellation may occur.

Recommended application is by spray, dipcoat, or roller.

Glass plates of (1x3) cm2 were dipcoated 15 times from the ZnS:Mn2+ suspension at a lift-rate of 0.5 mm/s while the suspension was slowly stirred.

Correlation between thickeness of membrane and withdrawing velocity in dipcoating fabrication process

The easiest approach to incorporating drugs into electrospun fibers is to dipcoat the fibrous constructs (mats, tubes, etc.) into appropriate organic or inorganic solvents that contain the drug in question.